IYHWrestling.com | WithoutYourHead.com

Welcome to In Your Head! Wrestling podcast, news and community!


Pages (1 of 1): 1

Category Index / Forum / Wrestling Forums


World Champ

Joined: Apr 21 2015
Posts: 989

00:02, May 30 2016

In the drawing process, the role of the die is drawn at a drawing stress σ1 drawing force unit cross-sectional area of ​​the wire on. To make the metal mold plastic deformation in the hole, drawing stress σ1 must be greater than the deformation resistance σT mold hole in the metal deformation zone; and in order to prevent the wire out of the die hole and continue deformation attenuated or pull off thereby destabilizing drawing process, drawing stress σ1 must be less than the die hole after the wire is drawn yield limit σs, and therefore for achieving the drawing process is usually expressed as: σT < σ1 < σs. The ratio of K's with the safety factor called drawing process302 stainless steel astm a 580

Subjected to cold-drawn wire produce significant deformation hardening, its yield limit σs value close to their ultimate strength σb, σb commonly used in the production of value instead of σs, thus achieving the drawing process conditions can also be expressed as σT < σ1 < σs; drawing process safety factor of K ratio σb with σ1 also available representationPerforated Stainless Steel Sheet Price

Safety factor
Drawing process safety factor K value is generally 1.40 to 2.0, K < 1.40 represents the drawing stress σ1 is too large, the die hole after the wire may continue to appear deformed attenuation or pull off phenomenon, unstable drawing process; K> 2.0 Description drawing stress σ1 smaller, pass drawing deformation amount is too small, drawing passes increased. The pull wire drawing diameter of less than 0.05mm ultra-fine wire, clothing die hard, in order to improve the stability of the drawing process, reduce the number of mold to pull off and wear, improve drawing productivity, safety factor K may be greater than 2.0wholesale stainless steel hexagon bars

World Champ

Joined: Sep 24 2014
Posts: 32917

23:17, Mar 06 2018

The watchs 45-mm case is made of satin-finished Replica Breitling and polished titanium and isengraved with Buchi’s signature https://michaelgoodman.jimdo.com/" class="TyTxtSmlC">Replica Watches geometric lines and shapes. The design motifcontinues seamlessly into the black calfskin strap, which is sewed Replica tag heuer watches ontorubber and hot-stamped in a gradient from black to gray. The rubber interior of the strap is also engraved with a Sang Bleu logo

World Champ

LOOT: 78395
Joined: Mar 08 2018
Posts: 38752

Pages (1 of 1): 1

2 replies to this thread.
Showing 20 replies per page.

Quick Reply

You must be logged in to post comments. [ Login, Register ]